Eldes EKB3 Installationshandbuch PDF herunterladen (Seite 137)

137

137EN

MANUAL ELDES ESIM264 V3.1

ATTENTION: The minimum wireless connection range between the wireless device and wireless antenna of ESIM264 system can be

0,5 meters.

32.6.3. EWS1 Zone, PGM Output & Tamper

Upon successful EWS1 indoor siren binding process,the system adds 1 wireless Instant zone and 1 wireless Siren PGM output. The wireless

zone is intended for EWS1 tamper control and the wireless PGM output is for siren control.

In case of tamper violation, the alarm is caused regardless of system being armed or disarmed. The wireless connection loss between EWS1

and ESIM264 system leads to alarm. The system identies this event as a tamper violation and sends alarm by SMS text message and phone

call to the user (-s) by default. The SMS text message contains the violated tamper number and a star * character indicating wireless connec-

tion loss as a tamper alarm cause.

ATTENTION: The tamper will not operate if the wireless zone is disabled.

32.6.4. Battery Replacement

1. Open EWS1 enclosure.

2. Remove all 3 old batteries from the battery slots.

3. Postition the 3 new 1,5V alkaline AA type batteries according to the appropriate battery slot positive/negative terminals indicated on the

PCB (printed-circuit-board) of EWS1

4. Insert the batteries into the battery slots.

5. Batteries replaced.

For more details, please refer to 32.6.2 Installation.

ATTENTION: Only CR2032 3V batteries can be used. Install only new, high quality and unexpired batteries. Do not mix the old batteries

with the new ones.

ATTENTION: At least 1 battery must be removed if the device is not in use.

ATTENTION: In order to avoid re or explosion hazards, the system must be used only with approved battery. Special care must be

taken when connecting positive and negative battery terminals. Dispose old batteries only into special collection sites. Do not charge,

disassemble, heat or incinerate old batteries.

NOTE: The battery status can be monitored in real-time using ELDES Conguration Tool software.

32.6.5. Restoring Default Parameters

1. Remove any battery from EWS1.

2. Press and hold the RESET button.

3. Insert the battery back to EWS1.

4. Hold the RESET button until LED indicator provides several short ashes.

5. Release the RESET button.

6. Parameters restored to default.

32.7. EWS2 – Wireless Outdoor Siren

Main EWS2 features:

• Audio alarm indication by built-in speaker;

• Visual alarm indication by built-in LED indicators;

• Range of operating temperature: -30...+55

EWS2 is a wireless outdoor device with a built-in siren speaker, LED indicators and operates with ELDES wireless alarm systems. EWS2 has to

be bind to the alarm system by sending a corresponding SMS text message or using software ELDES Conguration Tool. Upon successful EWS2

binding process, the system adds one wireless zone and one wireless PGM output. In case of alarm, the siren provides a sound alarm for one

minute. The conguration of this parameter is disabled for EWS2 in order to save the battery power.

It is possible to connect up to 16 EWS2 devices to the alarm system at a time. The maximum wireless connection range is 150 meters (in open

areas).

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 167 168

Kommentare zu diesen Handbüchern

Keine Kommentare

Eldes EKB3 Installationshandbuch Seite 137

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Eldes EKB3