Eldes EKB3 Installationshandbuch PDF herunterladen (Seite 41)

41EN

MANUAL ELDES ESIM264 V3.1

12.4. EKB3 Keypad and User Password

EKB3

Illuminated indicator READY on EKB3 keypad indicates that no violated zones and/or tampers are present, therefore the system

can be armed. If the indicator is not illuminated, the user must restore all violated zones and tampers before arming the system.

Alternatively, the violated zones can be bypassed (see 14.7. Bypassing and Activating Zones), disabled (see 14.9. Disa-

bling and Enabling Zones) or a Force attribute enabled (see 14.6. Zone Attributes).

To arm the system by EKB3 keypad, enter any out of 30 available 4-digit user passwords using the number keys on the keypad

(see 10. USER PASSWORDS for user password management). By default, when a valid user password is entered, the system

will initiate exit delay, the keypad’s buzzer will emit short beeps and the indicator ARMED will light ON. When the system is

successfully armed, the keypad’s buzzer will silent down.

Arm the system

Enter user password:

uuuu

Value: uuuu – 4-digit user password.

Example: 1111

To cancel the system arming process, enter the user password again during exit delay countdown.

To disarm the system by EKB3 keypad, enter any out of 30 available 4-digit user passwords using the number keys on the keypad. When a

valid user password is entered, EKB3 keypad indicator ARMED will light OFF.

Disarm the system

Enter user password:

uuuu

Value: uuuu – 4-digit user password.

Example: 1111

The system will arm/disarm the partition corresponding to the one that user password and the key pad are assigned to. For example, if

EKB3 keypad and user password is assigned to Partition 0, the user will be able to arm/ disarm only Partition 0. For more details on how

to set user password and keypad partition, please refer to 23.4. User Password Partition and 23.3. Keypad Partition and Keypad

Partition Switch respectively.

To arm/disarm a dierent partition than the keypad is assigned to, use keypad partition switch feature (by default – disabled) to switch the

keypad to a dierent partition before arm ing/disarming process. For more details on keypad partition switch and how to enable it, please

refer to 23.3. Keypad Partition and Keypad Partition Switch.

Use keypad partition

switch

Hold the [*] key, release it after 3 short beeps & enter partition number:

* p

Value: p – partition number, range – [0... 1]

Example: *1

NOTE: By default, User Password 1 is preset as 1111 and assigned to Partition 0.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 167 168

Keine Kommentare

Eldes EKB3 Installationshandbuch Seite 41