Eldes EKB3 Installationshandbuch PDF herunterladen (Seite 148)

148

148 EN

MANUAL ELDES ESIM264 V3.1

32.10. EWK2 - Wireless Keyfob

Main EWK2 features:

• Alarm system arming & disarming;

• Panic button;

• PGM output control;

• Sound indication by built-in mini buzzer;

• Visual indication by built-in LED indicator.

EWK2 is a wireless device intended to remotely arm and disarm ELDES alarm system, cause system alarm or to control any electric ap-

pliance connected to the alarm system’s PGM output. In order to start using wireless keyfob EWK2, it has to be bound to ELDES wireless

alarm system using ELDES Conguration Tool software or sending a corresponding SMS command. EWK2 keyfob features four congurable

buttons intended to operate according to individual needs. After the button is pressed, EWK2 internal buzzer’s sound signal and red LED

indicator conrms a transferred command to ELDES alarm system via wireless connection. The status of the sent command can be checked

by attempting to receive the feedback signal from the alarm system. This can be performed by pressing down the same button again and

holding it for 3 seconds. 3 short sound signals and LED indicator ashes indicate a successfully carried out command, while 1 long beep and

LED indicator ash stands for failed command and feedback signal failure. By default, one pair of buttons is already congured to arm and

disarm the alarm system. It is possible to connect up to 5 EWK2 devices to ELDES alarm system at a time. The maximum wireless connection

range is 150 meters (in open areas).

32.10.1. Technical Specications

Optional

functionality

Optional

functionality

Disarm the

system

Arm the

system

LED

indicator

NOTE: Figure reects the default EWK2 button conguration. All keyfob buttons are congurable according to individual needs.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 167 168

Keine Kommentare

Eldes EKB3 Installationshandbuch Seite 148